In January of 1937, a team of workmen at the Atlas Foundry, 3012 So. Wilkeson St. were photographed pouring molten metal into a small mold. In 1937 the Atlas Foundry employed 97 skilled workmen, and was the largest foundry on the Pacific Coast. Their three story pattern building housed over 50,000 wooden patterns, from which they could make castings varying in size from a 2-ounce bronze boat fitting to a 16-ton cast iron slag pot. Founded in 1899, the Atlas Foundry is now Atlas Casting & Technology. (TDL 3/28/1937)
Atlas Foundry furnace. Six workmen observing glowing furnace and an open grate in the floor in January of 1937. Two of the men are twisting a metal rod near the furnace.
By July of 1941, when this photograph was taken, the sprawling Atlas Foundry had already been located at South 30th and Wilkeson Streets for almost 40 years. Their complex of buildings was located between Center Street (the road showing at the bottom) and South Tacoma Way in the Center Street Industrial District at the east end of "Nalley's Valley". The Atlas Foundry was built right next to the Northern Pacific Rail Road tracks which ran past their north side. The dirt road going up the hill at left-center is Wilkeson Street. [Also dated 08-26-1941]
Atlas Foundry & Machine Company. Cranes and lifts for Broderick & Bascomb wire rope. A crane picks up metal scrap using a large magnetized plate. Atlas Foundry worked on their shop layout to increase efficiency as they prepare for possibly unprecedented large volumes of business this year. The foundry manufactured steel, iron and brass castings. The company was established in 1899 on a ten acre site at 3012 South Wilkeson. They were capable of producing 80,000 pounds of steel per day. (T.Times, 8/28/1946, p.5)
Atlas Foundry was giving over 100 Purchasing Agent's Association members a tour of their facilities. The tour would show the complete cycle machinery manufacturing and producing goes through. It started in the drawing room, followed by the pattern shop, brass foundry, steel foundry, cleaning department, sand laboratory and ended with the finished product. View of men looking at finished machinery pieces (T. Times, 2/19/47, p. 7).